In short
If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Pelham realigns or replaces the sensors and tests the safety reverse.

Doors that won't close in Pelham
Most of Pelham was built in the 1920s boom, and in the Village of Pelham, Pelhamwood and Chester Park the typical garage is a small detached building at the end of a narrow driveway, sometimes shared with the neighbor. Sensors there are mounted on old wood door frames, and the garage is used for storage as much as parking, so the beam is often blocked. In Pelham Manor, larger Tudors and Colonials have attached garages that are still narrow by modern standards. Near the station, lots are tight. Old street trees shed heavily each fall, and leaves against the door are the season's main cause.
Why a garage door refuses to close
- Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
- Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
- Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
- Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.
Three safe checks before you call
- Look at the small lights on both sensors. Each should be on and steady.
- Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
- Gently turn the blinking sensor until its light goes steady, then try the remote again.
If that doesn't do it, stop there. Don't tape the sensors together or bypass them.
How the repair is done
The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.
Around Pelham
- Chester Park: Older homes near the New Rochelle line, with narrow driveways.
- Station area: Pre-war streets on three sides of the Metro-North station.
See the full Pelham service area.